Volvo 164 1969 Service Manual page 236

11 . Fill the grease cap half full of grease and fit it
with tool SYO 2715.
12. Fit the front wheel brake unit accord ing to Part 5.
13. Lift on th e wheel after having cleaned any grit
and dirt froml the contact surfaces between the
wheel and hub, and then tighten up the nuts suffi-
ciently so that the wheel can not be displaced on
the hub. Lower the vehicle and tighten the wheel
nuts firmly. Tighten every other nut n little at a
time until all of them are finally tightened to a
torque of 10-14 kgm (70- 100 ft.lb .).. Fit the hub-
cap.
VOLVO
23808
svo
1801
Fig. 7·20. Fitting the sea li ng ring
Fig. 7·21. Lubrication of front wheel bearing
VO LVO
101 987
7 : 11