Kenmore SPACEMASTER 85210 Installation Instructions Manual page 16

STEP 6:
ATTACH THE OVEN TO THE WALL
6. Roof-vented installation: Align the damper/duct
connector with the vent on top of the microwave
oven. Damper should be on top of tab. Use two
tapping screws(bright-colored) to attach
damper/duct connector to the microwave oven.
See Figure 30.
NOTE: Damper/duct connector must be attached to
microwave oven after microwave oven is
installed.
7. Roof venting installation: Install ductwork through
the vent opening in the upper cabinet. Complete the
venting system through the roof according to the
method needed. See "Venting requirements," STEP
3 on the page 10. Use caulking to seal exterior roof
opening around exhaust cap. See Figure 31.
8. Use power supply cord clamp to bundle the power
supply cord. Install power supply cord clamp, using
screw as shown in Figure 31, to inside of the
cabinet.
9. Grasp filter screen with one hand holding the ring
and the other hand holding the opposite end. Insert
the end of the filter screen without ring into the
opening and slide towards the center of the
microwave oven. Insert ring end of filter screen into
the opening and slide entire screen towards the
side of the microwave until screen is securely in
position. Repeat for other filter screen.
See Figure 32.
10. Plug in the power supply cord.
11. Read your Use and Care Manual, then check the
operation of your microwave oven.
bolts
- 16 -
damper
Figure 30
power
supply
cord
clamp
Figure 31
Figure 32