Installation - BIRO 1433 Operating And Service Manual

PROPERLY INSTALL EQUIPMENT IN ADEQUATE WORK AREA
• ALWAYS Use Qualified Technician and Electrician for Installation.
• ALWAYS Install Equipment in Work area with Adequate Light and Space.
• ONLY Operate on a Solid, Level, Non-Skid Surface.
• NEVER Operate with Saw Guard Bar on Saw Guide Bar in the Raised Position or the Saw Guard Removed
from the Saw Guide Bar.
• ALWAYS Adjust Saw Guide Bar with Saw Guide to Within 1/2" of Product to be Cut.
• NEVER Operate Without all Warning Labels Attached and Wall Chart Posted.
1. Read this Manual thoroughly before installation and operation. Do not proceed with installation and operation if you have any
questions or do not understand anything in this Manual. Contact your local Distributor, or BIRO first.
2. Install machine on a level, solid, non-skid surface in a well-lighted work area away from children and visitors.
3. After installing machine in operational area, it is imperative that the four adjusting leg hex bolts be adjusted to level the
machine and also to eliminate rocking.
4. To assemble meat gauge plate (Part No. A14275) to the machine; Loosen the lock knob (Part No. 272-10) on the right side meat
gauge bracket. Remove the meat gauge gear rack (Part No. 14272) and insert into the meat gauge plate. Be sure to hold meat
gauge arm so that the release handle is depressed. Re-install the gear rack by first inserting the rectangle end into the left hand
meat gauge bracket, then swing the right hollow round end of the gear into the original lock position. Upon aligning the gear
rack with the capscrew (Part No. 272-11), tighten the lock knob clockwise, fastening the locking cap screw into the hollow end
to the gear rack, CHECKING for a secure assembly. Keep gear rack well oiled with food grade oil to ensure free movement.
5. The stainless steel head (Part No. S14005C) comes
detached from the base. Slide the head into the slide gibs
(Part No. 260) located on the back of the base structure.
Make sure the slide gibs are oiled or greased to ensure free
vertical movement of the head structure.

INSTALLATION

TO AVOID SERIOUS PERSONAL INJURY
ALWAYS LEVEL MACHINE BEFORE USING
3