Track 0 Sensor Removal; Figure 36: Track " Sensor Removal - Seagate ST212 Product Manual

TRACK 0 SENSOR REMOVAL
9.3.5
FIGURE 36:
Track
i1
Sensor
Removal
Required Tools: T-7 Torx driver, Loctite™ #242
Proper positioning of this sensor is essential. The Interrupter Arm set screw
is set at the factory and should not be tampered with.
1. If installed, remove the Front Panel.
2. Disconnect the Track 0 Sensor connector, P8. Slide the wires down between
the casting and the frame. Free the harness from the white retaining clip on
the casting. Refer to Figure 36.
3. Remove the sensor. Do not tamper with the Interrupter Arm set screw. This
is set and sealed at the factory.
SENSOR
~-+----::o""""r--STEPPER
MaTOR
"'~f-.-.#--+-----JL--INTERRUPTER
ARM
ST212 PRODUCT MANUAL/Rev. B
39