Transmitter Control (Rtf); Installing The Flight Battery - Blade Nano S2 Instruction Manual

Transmitter Control (RTF)

Flight mode
switch
Bind
switch
F
E
D
When pressed down, trim buttons make a sound that increases or decreases in pitch at each
pressing. The middle or neutral trim position is heard as a middle tone in the pitch range of
the sounds. The end of the control range is sounded by a series of beeps.
Aileron (Left/Right)
Mode 1
Throttle (Up/Down)
Aileron (Left/Right)
Mode 2
Elevator (Up/Down)
Dual Rate Selection
The control sensitivity can be changed by pressing and releasing the right control stick. The LED
on the transmitter will show solid for high sensitivity (default) and flashing for low sensitivity.

Installing the Flight Battery

1. Lower the throttle and throttle trim to the
lowest settings.
2. Power on the transmitter.
3. Install the flight battery in the battery
holder. Connect the battery cable to the
3-in-1 control unit.
NOTICE: Do not allow the helicopter to
move until the blue LED on the 3-in-1
control unit is solid.
NOTICE: Always disconnect the Li-Po
battery from the 3-in-1 control unit of the
aircraft when not flying. Failure to do so
may result in over discharge.
A B
Throttle
Trim
Elevator
Trim
Power LED/flight
mode indicator
ON/OFF
Switch
C D
Aileron Rudder
Trim Trim
Aileron Rudder
Trim Trim
7
E
Elevator Rudder (Left/Right)
Trim Elevator (Up/Down)
Throttle Rudder (Left/Right)
Trim Throttle (Up/Down)
Panic
Recovery
Dual rate
switch
A
B
C
F
EN