FBII XL-2T Installation And Setup Manual page 47

Question 07, L2 - CS Receiver Type 1...................................................................Default = 5
Enter the digit for the desired receiver type from the table below.
NOTE: The checkmarks highlight which options are selected.
FORMAT PULSE SPEED FREQUENCY
Digit 10 PPS
4
0
1
2
4 4
5
6
4
8
9
A
4
C
D
E
NOTE: The value placed in this digit will be ignored if transmitting in one of the DTMF for-
mats (FBII Superfast, ADEMCO PID, ADEMCO Express).
For UL installations, the acceptable receivers are FBII CP220 (all formats except ADEMCO Ex-
U L
press, 4x1 + 4x2, and ADEMCO High Speed), ADEMCO 685 (all formats without parity and not
FBII Superfast), Silent Knight 9000 (10PPS, No Parity, 1400, or 2300Hz).
Question 07, L3 - Dialer Disable, Dialing Format, and CS Reporting Type ............Default = 1
Enter the digit for the desired message length from the table below.
NOTE: The checkmarks highlight which options are selected.
DIALING FORMAT
U.S.
Digit PULSE PULSE
4
0
1
2
3
4
4
5
6
8 4
9
A
B
C
D
E
F
DIALING FORMAT - Specifies how this control panel will perform outgoing dialing over the
telephone line connected to the control panel (TouchTone, U.S. Pulse, or European pulse
format).
NOTE: Superfast TouchTone is a faster transmission of the TouchTone frequencies, and may
not be accepted in all telephone exchanges.
U L
The European dialer option has not been tested for UL installations.
BACKUP - CS#2 will back up CS#1.
DUAL - Both CS#1 and CS#2 will be dialed.
HANDSHAKE
20 PPS 40 PPS 1400 HZ 2300 HZ PARITY
4
4 4
4 4
4
4
4
4 4
4 4
4
4
EUROPEAN
TOUCHTONE
4
4
4
4
4
4
Section 6 - System Programming
TYPICAL CS RECEIVER
FBII, ADEMCO, SILENT KNIGHT
FBII, ADEMCO, RADIONICS
FBII
4 FBII, RADIONICS
4
FBII
4 FBII, RADIONICS
4
FBII, RADIONICS
4 FBII
4
FBII
4 4
FBII
4 4
FBII
4 4
FBII, RADIONICS
CS REPORTING TYPE
SUPERFAST
TOUCHTONE BACKUP
4
4
4
4 4
4
DIALER
DUAL SPLIT DISABLED
4
4
4
4
4
4
4
4
4
4
4
6–5