Unit Function Setting By The Remote Controller (For Mr. Slim P Series) - Mitsubishi MA Series Technical Manual

VI. Unit Function Setting by the Remote Controller (for Mr. SLIM P Series)
Perform the following settings only to change the functions for Mr. Slim series.
(This setting is not possible with the City-Multi series.)
Each unit's functions can be set by a remote controller. Setting of each unit's functions is possible by remote controller only.
Table Functions Available (For details regarding initial settings and operation modes of each unit, refer to the unit installation
manual.)
(1) Itemised functions of the entire refrigerant system (select unit number 00)
Function
Not available
Power failure
Available
automatic recovery
(Approx. 4-minute wait-period after power is restored.)
Average data from each indoor unit
Indoor temperature
Data from the indoor unit with remote controllers
detecting *1
Data from main remote controller
Not supported
LOSSNAY
Supported
connectivity
Supported
230V
Power voltage
208V
Auto operating mode
Auto energy-saving operation ON
*2
Auto energy-saving operation OFF
2 C [ 36 F ] (Normal)
Frost prevention
3 C [ 37 F ]
temperature
Standard
Defrosting control
For high humidity
*1. Can be set only when a wired remote controller is used. This function cannot be set for fl oor type models.
When using two remote controllers (two-remote controller operation), the remote controller with a built-in sensor must be set as the main re-
mote controller.
Meaning of "Function setting"
Mode No.02 : indoor temperature detecting
No Indoor temperature : ta
No1. Average data of the
sensor on all the
indoor units
No2. the data of the sensor
on the indoor unit that
connected
with remote controller
No3 the data of the sensor
on main remote
controller.
*2. Can be set only when the outdoor unit is an inverter type.
38
Settings
(Indoor unit does not intake outdoor air through LOSSNAY.)
(Indoor unit intakes outdoor air through LOSSNAY.)
OUTDOOR
INDOOR INDOOR
REMOTE REMOTE
(MAIN) (SUB)
factory ta=(A+B)/2
setting
ta=A
ta=C
Mode No. Setting No.
OUTDOOR
INDOOR INDOOR
REMOTE REMOTE
(MAIN) (SUB)
ta=(A+B)/2
ta=B
ta=C
Check
1
1
2
1
2
2
3
1
2
3
3
1
4
2
1
5
2
1
15
2
1
17
2
OUTDOOR OUTDOOR
INDOOR INDOOR
REMOTE REMOTE REMOTE
(MAIN) (SUB) (MAIN)
ta=A ta=A
ta=A ta=A
ta=C ta=C
Remarks