Measuring Ports - Deepace KC901M User Manual

STOP/RUN Stops sweeping, starts sweeping (Toggles between each mode)
Same as function as rotating knob, but the step is larger than the knob.
+、-
MARK Enters into the cursor function menu (and activates knob for marker
control)
AMP Amplitude menu allows adjusting of the reference level, trajectory
position, the range of the signal source function as well as the vertical
extent in VSWR test.
POWER Power switch
SHIFT Allows selection of the secondary functions
CENT and SPAN button function can be set in "Frequency control" which is in the
FUNC menu.
Chart of Keyboard's secondary functions
Key Combination
SHIFT+CENT
SHIFT+SPAN
SHIFT+LOCAL
SHIFT+FUNC
SHIFT+STOP/RUN Switching to the single step sweeping. In this mode, press
SHIFT+1
SHIFT+2
SHIFT+3
SHIFT+4
SHIFT+5
SHIFT+6
SHIFT+.
SHIFT+0
SHIFT+ENTER

2.2 Measuring Ports

There are three signal ports in KC901M. Two external RF ports (50 ohms), one AF
port (1Kohm). The far right one is Port 1, the input/output port for testing spectrum
and reflection. The far left one is Ports 2, generally the output port for transmission
measurement and the output of RF signal source. Inside the instrument, there is
Chart 2-1
Setting the beginning(start) frequency
Setting the ending(stop) frequency
Disconnecting to the computer and forcibly switching to the
local operation
Resetting to defaults
STOP/RUN once, sweep once.
Saving the data to the storage card
Read the curves and settings from the storage card
Self-defining the file names after saving the data into the storage
card
Adjusting the screen luminance
Adjusting the RF output range
On/off the key tone
Saving the current user calibration data
Reading the user calibration data
Locking the keyboard and knob to prevent accidental
operation
Chart 2-2
Functions to use
- 9 -