Table of Contents
Advertisement
Advanced VLAN Setup Example (Triply Play)
VLAN_data:
Ethernet Port 1, Wireless and Wireless WDS are reserving for Internet
- On Ethernet port 1 I also need VC 0/40 bridged.
VLAN_Vedio
Ethernet ports: 2, 3 and 4:
- 0/33 Bi-directional IP
- 0/34 Video
- 0/35 Video
- 0/36 Video Subscriber Services (EPG, EAS, etc.)
- 0/37 Video
- 0/38 Video
- 0/39 Spare
Step 1: Setup Member Ports
Go to Configuration
You can setup member ports for each VLAN group under Bridge Interface section. From the example,
two VLAN groups need to be created.
Ethernet: P1 (Port 1)
Ethernet1: P2, P3 and P4 (Port 2, 3, 4) Please uncheck P2, P3, P4 from Ethernet VLAN Port first.
Note: You should setup each VLAN group with caution. Each Bridge Interface is arranged in this order.
Bridge Interface
Ethernet
Ethernet1
Ethernet2
Ethernet3
Step 2: Create WAN Interface
Go to Configuration
wanlink is the factory default WAN interface which in service for data/internet access. If your ISP uses
this access protocol, click Edit to input other parameters if needed. If your ISP does not use PPPoE,
you can change the default WAN connection entry by clicking Change.
From the example, 0/40 is used for data/internet and assumes PPPoE is used; click the Edit to change
the VPI/VCI to 0/40.
Click Create to setup up additional WAN interface for video applications. Total of 8 VLAN is support;
therefore, only 8 WAN interfaces can be created in the table.
Chapter 4: Configuration
LAN
Bridge Interface.
WAN
ISP
BiPAC 7402R2 ADSL2+ VPN Firewall Router
VLAN Port (Always starts with)
P1 / P2 / P3 / P4
P2 / P3 / P4
P3 / P4
P4
126
Advertisement
Table of Contents
