Sony UDA-1 How To Use Manual page 28

Usb dac amplifier
Hide thumbs Also See for UDA-1:
Table of Contents

Advertisement

AMPLIFIER flash.
All the input indicator lamps flash.
When an abnormal current is output to the SPEAKERS terminals, or when the internal temperature of
the USB DAC AMPLIFIER is too high, etc., all the input indicator lamps flash for 5 seconds, and the
USB DAC AMPLIFIER turns off automatically.
The power lamp flashes.
If the AUTO STANDBY switch is set to "ON," when you are not using the USB DAC AMPLIFIER or
when there is no digital signal input to the USB DAC AMPLIFIER for 20 minutes, the USB DAC
AMPLIFIER is automatically turned off. Before the USB DAC AMPLIFIER turns off, the power lamp
flashes for 1 minute.
The USB FRONT lamp flashes.
When you connect a device that is not supported by the USB DAC AMPLIFIER to the
on the front panel, the USB FRONT lamp flashes slowly. Disconnect the device.
When an abnormal current is being input to the
AMPLIFIER, the USB FRONT lamp flashes quickly. Check whether there is a problem with the device
connected.
The USB REAR, COAXIAL, or OPTICAL input indicator lamp flashes.
When a signal of a format not supported is input, the corresponding lamp flashes.
The DSEE lamp flashes.
If you press the DSEE button when the DSEE function setting cannot be changed, the DSEE lamp
flashes three times.
[37] Troubleshooting
Sound input from the LINE IN jacks of the USB DAC
AMPLIFIER does not output through the LINE OUT
jacks.
The LINE OUT jacks of the USB DAC AMPLIFIER do not output sound signal input from the LINE IN
jacks, because doing so may damage the USB DAC AMPLIFIER depending on the devices
connected.
[38] Troubleshooting
No sound is output.
Dealing with problems
Dealing with problems
(USB) port on the front panel of the USB DAC
General
Sound
(USB) port

Advertisement

Table of Contents
loading

Table of Contents