Adjusting The Sound Characteristics; Quickly Attenuating The Sound; Changing The Sound And Display Settings; Menu - Sony CDX-CA660X Primary Operating Instructions Manual

Adjusting the sound
characteristics
You can adjust the bass, treble, balance, and
fader.
The bass and treble levels can be stored
independently for each source.
1
Select the item you want to adjust by
pressing (SOUND) repeatedly.
Each time you press (SOUND), the item
changes as follows:
BAS (bass) t TRE (treble) t
BAL (left-right) t FAD (front-rear)
2
Adjust the selected item by pressing
either side of (SEEK).
When adjusting with the rotary
commander, press (SOUND) and rotate the
VOL control.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
(With the rotary commander or the card
remote commander)
Press (ATT) on the rotary commander or
card remote commander.
After "ATT-ON" momentarily appears, the
"ATT" appears in the display.
To restore the previous volume level, press
(ATT) again.
18
Changing the sound and
display settings
The following items can be set:
SET (Set Up)
•CLOCK (page 9)
•BEEP — to turn the beeps on or off.
•RM (Rotary Commander) — to change the
operative direction of the controls of the
rotary commander.
— Select "NORM" to use the rotary
commander as the factory-set position.
— Select "REV" when you mount the rotary
commander on the right side of the
steering column.
•P.OUT-4.0V/P.OUT-5.5V — to change the
pre-out of the power amplifier to 4.0 V or
5.5 V. Selectable only when the unit is turned
off. (CDX-CA660X only)
Note
If the volume is turned up very high when
connected to a power amplifier, the sound may be
distorted. In this case, set P.OUT to "4.0V."
DSPL (Display)
•D.INFO (Dual Information) — to display the
clock and the play mode at the same time
(ON).
•M.DSPL (Motion Display) — to select the
Motion Display mode from "1," "2," and
"OFF."
— Select "1" to show decoration lines in the
display and activate Demo display.
— Select "2" to show decoration lines in the
display and deactivate Demo display.
— Select "OFF" to deactivate the Motion
Display.
•A.SCRL (Auto Scroll)
— Select "ON" to scroll all automatically
displayed names exceeding 8 characters.
— When Auto scroll is set to off and the
disc/track name is changed, the disc/
track name does not scroll.
SND (Sound)
•LOUD (Loudness) — to enjoy bass and treble
even at low volumes. The bass and treble will
be reinforced.

— Menu