Changing The Sound And Display Settings; Adjusting The Frequency Of The Subwoofer(S) - Sony CDX-C780 Primary Operating Instructions Manual

Changing the sound and
display settings
You can set:
•Clock (page 7).
•D.Info (Dual Information) to display the
clock and the play mode at the same time
(ON) or to display the information
alternately (OFF).
•Amber/Green to change the illumination
color to amber or green.
•Dimmer to change the brightness of the
display.
— Select "Auto" to dim the display only
when you turn the lights on.
— Select "on" to dim the display.
•Contrast to adjust the contrast if the
indications in the display are not
recognizable because of the unit's installed
position.
•Beep to turn on or off the beeps.
•RM (Rotary Commander) to change the
operative direction of the controls of the
EN
rotary commander.
— Select "norm" to use the rotary
commander as the factory-set position.
— Select "rev" when you mount the rotary
commander on the right side of the
steering column.
•Loud (Loudness) to enjoy bass and treble
even at low volume. The bass and treble will
be reinforced.
•LPF (Low Pass Filter)
•A.Scrl (Auto Scroll) (page 8, 19).
1
Press (SHIFT).
2
Press (3) (SET UP) repeatedly until the
desired item appears.
Each time you press (3) (SET UP), the item
changes as follows:
Clock n D.Info* n Amber/Green n Dimmer
n Contrast n Beep n RM n Loud* n LPF*
n A.Scrl*
* When you have not tune the station or there
is no CD/MD being played, these items will
not appear.
Note
The displayed item will differ depending on
the source.
18
3
Press (5) (n) to select the desired
setting (for example: on or off).
For the "Contrast" setting, pressing (5)
(n) makes the contrast higher, and
pressing (2) (N) makes the contrast lower.
4
Press (SHIFT).
After the mode setting is complete, the
display goes back to normal playback
mode.
Adjusting the frequency
of the subwoofer(s)
To match the characteristics of the connected
subwoofer(s), you can cut out the unwanted
high and middle frequency signals entering
the subwoofer(s). By setting the cut-off
frequency, the subwoofer(s) will output only
low frequency signals so you can get a clearer
sound image.
1
Press (SOURCE) to select a source (radio,
CD or MD).
2
Press (SHIFT), then press (3) (SET UP)
repeatedly until "LPF" appears.
3
Press (5) (n) or (2) (N) repeatedly to
select desired setting.
Each time you press (5) (n) or (2) (N),
the cut-off frequency in the display changes
as follows:
LPF off ˜ LPF 80 Hz ˜ LPF 120 Hz
4
Press (SHIFT).
When the frequency setting is complete, the
display goes back to the normal playback
mode.