Oliso smartiron TG1050 User Manual page 2

When using your iron, basic safety precautions should always be followed, including the following:
1
Use iron only for its intended use.
2
To protect against a risk of electric shock, do not immerse the iron in water or other liquids.
The iron should always be turned to "O " before plugging or unplugging from the outlet.
3
Never tug cord to disconnect from the outlet; instead, grasp plug and pull to disconnect.
Do not allow cord to touch hot surfaces. Let iron cool completely before putting away.
4
Loop cord loosely around iron when storing.
5
Always disconnect iron from electrical outlet when filling with water or emptying and when not in use.
6
The iron is not to be used if it has been dropped, if there are visible signs of damage, or if it is leaking.
Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of
7
electric shock, do not disassemble the iron. Take it to a qualified serviceperson for examination and repair.
Incorrect reassembly can cause a risk of electric shock when the iron is used.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
8
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
9
Children should be supervised to ensure that they do not play with the appliance.
Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron
10
upside down - there may be hot water in the reservoir.
If the LED flashes orange (not red or green), the iron is not operating normally.
11
Disconnect from the power supply and have the iron serviced by a qualified serviceperson.
12
When placing the iron on its stand, ensure that the surface on which the stand is placed is stable.
oliso® irons are high wattage appliances - For EU version is 2000-2400W at 220-240V. For US or Canada version
1 is 1600W at 120V for models TG1050 or 1800W at 125V for models TG1100, TG1250Pro or TG1600Pro.
To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
If an extension cord is absolutely necessary, a 15A cord should be used. Cords rated for less amperage may
2
overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.
3
This iron uses hot steam!
4
Never direct fill the iron from a water tap while the iron is plugged into a power source.
5
FOR HOUSEHOLD USE ONLY.
2
important safety instructions
read all instructions before using this product
special instructions
please save these instructions