Steam Selector - Oliso smartiron TG1050 User Manual

problem things to check
Is fabric selector set to o ?
Iron does
Is iron plugged in correctly?
not heat
Is auto shut-o system activated?
Scorch
Is itouch® switch set to o ?
Guards
™
Is iron plugged in correctly?
do not
come out
Is handle activated?
Is iron hot enough?
Iron does
Is steam selector set to o ?
not steam
Is steam valve clogged?
Is itouch® o , and iron is horizontal?
Iron
leaks
Is iron is hot enough?
Has steam burst button been overused?
Iron is
emitting a
brown Is water hardness too high?
or white
substance
The soleplate should be cleaned if starch or other residue builds up. When the iron is cool, wipe the soleplate with a soft, damp cloth.
Mineral deposits from tap water can occur in the soleplate vents. To clean, fill the water tank and heat the iron to the linen fabric setting. Once the iron
is fully heated, unplug the iron and hold over a sink. Press the steam button repeatedly until water begins to drip out of the soleplate.
To ensure optimal steam production, the steam valve should be regularly cleared of accumulated debris and minerals. This is done by moving the
10
trouble shooting guide
solution
Turn the fabric selector knob to a fabric setting.
Check to make sure the plug is fully plugged into the socket.
Touch the handle.
Set the switch on the back of the iron to the ON position.
Check to make sure the plug is fully plugged into the socket.
Move your hand away from the iron, and the itouch® technology will raise the soleplate.
The fabric selector must be set to the wool, cotton or linen settings to produce continuous steam.
Steam selector must be turned to a setting.
Move the steam selector from o (
When the itouch® switch is set to OFF, always store the iron in the vertical position.
We recommend turning on the itouch® technology to store the iron.
Make sure the fabric selector knob is set to the cotton or linen range to
ensure proper steam production.
Allow 3 seconds between uses of the steam burst function.
Switch to either spring water or half tap/half distilled water mixture.
See water recommendations on page 7.
maintenance + cleaning
Do not use abrasive cleaners or scouring pads as this will damage the iron's soleplate.
Be careful, as this creates large amounts of steam.
steam selector back and forth from the o (
If problems persist please visit
) to the max (
) to the max ( ) steam settings several times.
oliso.com/faqs
) settings a few times to unclog.