Commissioning Sitrans Th/Tr With Hart - Siemens SITRANS Series Compact Operating Instructions

Commissioning

5.3 Commissioning SITRANS TH/TR with HART

Procedure
1. If you want to change the factory settings, configure the device using the USB modem and
the SIPROM T parameter assignment software.
– Read the operating instructions for information on this.
2. Install the device.
Installing SITRANS TH in a connection head (Page 23)
Installing SITRANS TH on DIN rail and G rail (Page 24)
Installing SITRANS TR on DIN rail (Page 25)
3. Connect the device.
Connecting TH320 (Page 33)
Connecting TH420 (Page 34)
Connecting TR320 (Page 35)
Connecting TR420 (Page 37)
4. Switch on the power supply.
Switching on the supply voltage (Page 57)
5. Wait for 2 seconds.
After this start-up time, the device is operational.
6. Wait 5 minutes to get exact measured values.
Result
The LED is lit green.
5.3 Commissioning SITRANS TH/TR with HART
Introduction
In this section, you will learn how to commission the device step-by-step.
Before you start, please read the following safety notes:
● General safety notes (Page 15)
● Basic safety notes: Installing/mounting (Page 19)
● Basic safety notes: Connecting (Page 31)
● Basic safety notes: Commissioning (Page 53)
Read the entire device manual in order to achieve the optimum performance of the device.
54
SITRANS TH320/TH420/TR320/TR420/TF320/TF420
Compact Operating Instructions, 03/2018, A5E41865021-AA