Check Settings Of The 7-Day Time Switch; 24-Hour Mode With One Heating Period - Siemens REA22 Basic Documentation

3.3.2

Check settings of the 7-day time switch

Note
3.3.3

24-hour mode with one heating period

Note
CE1P2276E / 31.03.1999
16/30
The controller offers the possibility to check your settings of the 7-day time switch mode.
Proceed as follows:
Move the operating mode selector to the position at the top.
Auto 1...7
1
Day 6
1
If corrections have to be made on your settings, proceed as described in the previous
section.
The controller can be assigned to a 24-hour switching pattern with one heating phase.
Proceed as follows:
Move the operating mode selector to 24-hour mode with one heating
period, enabling its block and switching pattern to be set. With that, you
will afterwards use the 24-hour setting with one heating period.
Select the switching position (e.g. P.1) and press
P.1 the required switching time. Enter switching position P.2 accordingly.
T1
Select the temperature position (e.g. T1) and press
the required temperature. T1 is the temperature between the switching
points P.1 and P.2.
Select «Economy temperature» and press
quired value.
Auto
Move the setting slider back to this position and close the cover.
Run
If a position cannot be set, the display shows
Basic Documentation REA22
Description of end-user settings
- 5
Press button. The switching patterns set for the individual
- 7
... 7
days are shown in consecutive order.
Issue 2.0
to enter the re-
.
Siemens Building Technologies
Landis & Stefa Division
to enter
to enter