Chrysler Sebring 2005 Service Manual page 431

8A - 6 AUDIO/VIDEO
ANTENNA BODY & CABLE (Continued)
(4) Check the resistance again with an ohmmeter.
If the resistance is still more then one ohm, replace
the faulty antenna body and cable.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Pull the right side trunk liner aside.
(3) Remove antenna mast by unscrewing mast
from antenna body.
(4) Remove screw from mounting bracket.
(5) Pull antenna body down through the rubber
grommet.
(6) Unplug antenna lead from base of antenna
body.
INSTALLATION
(1) Insert antenna lead to base of antenna body.
(2) Push antenna body up through the rubber
grommet.
(3) Install screw into mounting bracket. Tighten
screw to 12 N·m (106 in. lbs.).
(4) Install antenna mast. Tighten to 12 N·m (106
in. lbs.) En s u re th a t th e a n te n n a m a s t is fu lly
s e a te d o n a n te n n a ba s e a n d th a t th e re is n o g a p
be tw e e n th e m a s t a n d ba s e .
(5) Install trunk liner.
(6) Connect battery negative cable.
CD CHANGER
DESCRIPTION
The In-Dash CD Changer (if equipped) is located in
the instrument panel below the radio. The remote
changer does not use a cartridge or magazine for the
CD's. Up to 6 CD's can be directly loaded into this
unit, one at a time.
OPERATION
Due to its compact design, the CD changer can
carry out only one operation at a time. For example,
you can not load a new disc while playing another at
the same time. Each operation happens sequentially.
The radio unit provides control over all features of
the CD changer with the exception of the CD load
and eject functions, which are controlled by buttons
located on the front of the CD changer. All features
you would expect, such as Disc Up/Down, Track
Up/Down, Random and Scan are controlled by the
radio, which also displays all relevant CD changer
information on the radio display.
On JR27 models, the CD changer will not operate
with the ignition in the OFF position. With the igni-
tion OFF, CD's can not be removed from the changer.
The CD changer contains a Load/Eject button and
an indicator LED for each of the six disc positions as
well as an illuminated disc opening. The individual
LED indicates whether a CD is currently loaded.
Pressing the Eject button will eject the disc presently
selected. If the chamber is currently empty, actuating
the Select button will position that chamber to
receive and load a new disc in that chamber.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove lower center trim bezel.
(3) Remove screws from radio.
(4) Remove screws from CD changer (Fig. 2).
Fig. 2 CD CHANGER
(5) Remove CD changer from Instrument panel.
(6) Disconnect wire connector from CD changer.
INSTALLATION
(1) Connect wire harness connector to CD changer.
(2) Insert CD changer into instrument panel.
Make sure that bumper on back of changer is
inserted into instrument panel opening.
(3) Pull radio from instrument panel far enough to
reach behind. Pull CD changer cable through radio
opening while inserting changer into instrument
panel.
(4) Install radio.
(5) Install screws to radio and CD changer.
(6) Install lower center trim bezel.
(7) Connect battery negative cable.
JR