Advertisement
5. Remove the four screws on the metal bracket
holding the hard disk drive.
Note: These screws are different from the screws
securing the hard disk drive cover and not
interchangeable. Place them separately!
Fig. 7 Remove the screws holding the hard disk drive.
Step 4 - Installing the New Hard Disk Drive
1. Check the jumper setting on the new drive; make
sure you set the jumper to the same position
(Master, Slave or Cable Select) as on the re-
placed drive.
Fig. 9 Check the hard disk drive jumper setting.
Your digital playground
6. Carefully slide the hard disk drive out of the
bracket.
Fig. 8 Separate the drive from the bracket.
2. Slide the new drive into the bracket (in the same
position as the replaced drive) and secure it with
the four screws.
Fig. 10 Slide the new hard disk drive into the bracket.
Packard Bell Easy Repair - 5
Advertisement
