Connection To The Mains Supply; Operation Instructions - FRIGOGLASS ICM2000 [R290] User Manual

b. Always ensure that your merchandiser is installed on a stable surface/floor and is properly
leveled. There are 2 adjustable feet at the front, under the chassis. Please, adjust until the ICM
levels and check using a spirit level, if available.
Mains connection: If the mains cord supplied is not long enough, do not use an extension lead and do
not replace it. Ask an authorized electrician to replace the cord with a longer one.
c. The merchandiser must stand upright for at least 1 hour after transportation and prior to start-up.
This gives the oil time to run back to the compressor after transit and installation.
d. Allow a minimum gap of 100mm at the top, 100mm at the rear and 50mm at the sides of the
cooler for proper ventilation.
e. Do not place anything on top of the cooler.
3.2

Connection to the mains supply

Connect the ICM to a 220-240 Volts power supply on a min. 10A-16A fused & grounded socket. Do
not use extension cables.
3.3

Operation instructions

*
The thermostat or the controller* are located behind the ICM. The thermostat is factory set to approx.
+4.1℃. If you require a higher temperature (warmer), turn the thermostat knob anticlockwise. If you
require a lower temperature (colder), turn the thermostat knob clockwise.
For instructions on the functionality of Danfoss ERC-112 Controller and its related optional features,
please visit the following website link: http://www.frigoglass.com/manuals/.
*
feature depending on model
Do not connect the merchandiser to:
a non grounded wall socket or power line
improper supply voltage and frequency
power supply that does not comply with the safety regulations of
the appliance or with current legislation on electrical installations
Do not plug the cooler into a multiple outlet strip or use
extension cables.
If the mains cord supplied is not long enough, do not use an
extension lead. Ask an authorized electrician to replace the cord
with a longer one, only if this is described in the list of authorized
spare parts.
Route the power cables in such a way that they are protected
from damage and they do not pose a risk of tripping.
ENG
11