Honeywell N05 Series Product Data page 3

N05,N10 SERIES DAMPER ACTUATORS FOR MODULATING AND FLOATING CONTROL
Table 1 describes, for the floating mode, the shaft adapter
behavior ("stops," rotates "CCW," or rotates "CW") in dependence
upon the control signals applied to terminals 3 and 4 and upon
the function selection switch setting.
Table 2 describes, for the 2-position mode, the shaft adapter
behavior ("stops," rotates "CCW," or rotates "CW") in dependence
upon the control signals applied to terminals 3 and 4 and upon
the function selection switch setting.
control signal at
terminal 3 terminal 4
open open
open 24 Vac/dc
24 Vac open
control signal at
terminal 3 terminal 4
24 Vac open
24 Vac 24 Vac/dc
control signal at
terminal 3
open
< min control signal plus 0.24 V
between min. control signal plus 0.24 V
and max. control signal minus 0.24
> max. control signal minus 0.24 V
Table 1. Shaft adapter behavior in the floating mode
0[2]...10V
-- stops
-- CCW
-- CW
Table 2. Shaft adapter behavior in the 2-position mode
0[2]...10V
-- CW
-- CCW
Table 3. Shaft adapter behavior in the modulating mode
terminal 4
open
24 Vac/dc
open
24 Vac/dc
open
24 Vac/dc
open
24 Vac/dc
Table 3 describes, for the modulating mode, the shaft adapter
behavior ("stops," rotates "totally CCW," rotates "totally CW," runs
to "proportional" position, or runs to "50%" of max. stroke) in
dependence upon the control signals applied to terminals 3 and 4
and upon the function selection switch setting.
switch settings
Dir Service/Off
stops
stops
stops
switch settings
Dir Service/Off
stops
stops
switch settings
0[2]...10V Dir
totally CCW -- stop
50% -- stop
totally CCW -- stop
50% -- stop
proportional -- stop
50% -- stop
totally CW -- stop
50% -- stop
3
Rev 10...0[2] V
stops --
CW --
CCW --
Rev 10...0[2] V
CCW --
CW --
Service/Off Rev 10...0[2] V
-- totally CCW
-- 50%
-- totally CW
-- 50%
-- proportional
-- 50%
-- totally CCW
-- 50%
CN0B-0545CH33 R0805
63-6233T