Rear Wheel - Yamaha FZ150i 2013 Owner's Manual

Rear wheel

1
1. Locknut
Removing the rear wheel
1.
Loosen the locknut and drive chain
slack adjusting nut on each side of
the swingarm.
2. Loosen the axle nut.
3. Place the motorcycle on the center-
stand.
4. Remove the axle nut.
5. Push the wheel forward, and then
remove the drive chain from the rear
sprocket.
PERIODIC MAINTENANCE AND MINOR REPAIR
NOTICE
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
6. While supporting the brake caliper
and slightly lifting the wheel pull
the wheel axle out.
NOTICE
A rubber mallet may be useful to
tap the wheel axle out.
7. Remove the wheel
.
NOTICE :
Do not apply the brake after the
wheel has been
together with the brake disc,
otherwise the brake pads will
be forced shut.
6-33
To install the rear wheel
1. Install the drive chain onto the
rear sprocket.
2. Install the wheel by inserting the
wheel axle from the left-hand side.
NOTICE
Make sure the washer is installed
onto the wheel axle before installing
the wheel axle.
3. Install the washer and the axle nut.
4. Adjust the drive chain slack.
5. Take the motorcycle off the cent-
erstand so that the rear wheel is
on the ground.
removed
6. Tighten the axle nut to the specified
torques.
TIP
When tightening the axle nut, hold
the wheel axle with a wrench to
keep it from turning.
Tightening torques
90 Nm (900 Kg/cm)
6
Axle nut :