Yamaha FZ150i 2013 Owner's Manual page 46

1. Maximum level mark
2. Minimum level mark
TIP
The coolant should be between the
minimum and maximum level marks.
3. If the coolant is at or below the
minimum level mark, remove panel.
(See page 6-5.)
4. Remove the coolant reservoir cap,
and then add coolant to the maxi-
mum level mark.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Coolant reservoir cap
Coolant reservoir capacity (up to the
maximum level mark):
0.24 L
NOTICE
If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the engine may not be
6-11
sufficiently cooled and the cool-
ing system will not be protected
against frost and corrosion.
If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
WARNING
Never attempt to remove the radiator
cap when the engine is hot.
5. Install the coolant reservoir cap.
6. Place the panel in the original posi-
tion, and then tighten the bolt
TIP
The radiator fan is automatically
switched on or off according to the
coolant temperature in the radia-
tor.
If the engine overheats, see page
6-36 for further instructions.
6