Coolant - Yamaha FZ150i 2013 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
NOTICE
Before installing the engine oil drain
bolt, do not forget to install the O-
ring, compression spring, and oil
strainer in position.
Tightening torque:
Engine oil drain bolt:
32 Nm (3.2 m·kgf, 23 ft·lbf)
9. Add the specified amount of the
recommended engine oil, and then
install and tighten the oil filler cap.
6 Recommended engine oil:
See page 8-1.
Oil quantity:
With oil filter element replacement:
1.00 L (1.04 US qt) (0.87 Imp.qt)
Without oil filter element replace-
ment:
0.95 L (0.92 US qt) (0.83 Imp.qt)
NOTICE
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
Make sure that no foreign mate-
rial enters the crankcase.
10. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
11. Turn the engine off, and then
check the oil level and correct it if
necessary.
6-10

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
The coolant level should be checked as
follows before each ride. In addition,
the coolant must be changed at the in-
tervals specified in the periodic mainte-
nance and lubrication chart.
1. Place the vehicle on the center-
stand.
TIP
The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Check the coolant level in the cool-
ant reservoir.