Konica Minolta ViZion DR+ 1417V2 Dealers Installation Manual page 14

Wireless panel
Hide thumbs Also See for ViZion DR+ 1417V2:
Table of Contents

Advertisement

3.2.2 ViZion DR+ 1417V2 Wireless Panel in
AP Mode (Alternative method)
When the panel is in AP mode you will connect
to the panel's broadcasted Wi-Fi network,
(which will be named the same as the serial
number of the panel), using the laptop's internal
wireless adapter. For your internet connection,
you will connect to any available Wi-Fi network
using the external USB Wi-Fi adapter.
Equipment required for AP mode:
ASUS Dual-Band Wi-Fi USB Adapter
(used for the Wi-Fi Internet connection)
Link Cable (to preconfigure the panel's
wireless settings)
Note: you will configure the panel into AP
mode later in Section 4.7.3, once
you get to that part of the
installation.
For now, during the installation, we need the
Link cable connected to the LAN Ethernet port
the same as in Section 3.2.1. Once the
installation is complete, follow the steps below
to configure the Wireless network adapter for
use in wireless AP mode.
1. From Control Panel, select Network
Connections, and right-click on the Intel
Wireless adapter and select
Properties.
2. Select Internet Protocol Version 4
(TCP/IPv4) and click Properties.
3. Select Use the following IP address
radio button.
[ViZion DR+ 1417V2 Wireless Panel Installation Manual]
Customer Support
4. Enter the following settings:
IP address 192.168.8.188
Subnet mask 255.255.255.0
5. Click OK to save the changes.
6. But during the installation, we need to
have the Link cable connected, so follow
the steps in Section 3.2.1 for now.
7. Connect the ethernet RJ-45 end of the
Link cable to the LAN Ethernet port on
the laptop computer.
8. Connect the mini-HDMI end of the Link
cable to the Link port on the side of the
panel.
9. Plug in the ASUS Dual-Band Wi-Fi
USB Adapter and wait for the drivers to
install. This adapter will be used to
connect to Wi-Fi networks for your
internet connection. Driver software
should install automatically or from CD.
10. Proceed to Section 4.
1.800.366.5343 –
HCITsupport@konicaminolta.com
14
[Ultra 4.2.9.0]

Advertisement

Table of Contents
loading

Table of Contents