Table of Contents
Advertisement
1. From Control Panel, select Network
Connections, and right-click on the Intel
Local Area Network Ethernet adapter
and select Properties.
2. Select Internet Protocol Version 4
(TCP/IPv4) and click Properties.
3. Select Use the following IP address
radio button.
4. Enter the following settings:
•
IP address 192.168.8.188
•
Subnet mask 255.255.255.0
5. Click OK to save the changes.
6. Connect the ethernet RJ-45 end of the
Link cable to the LAN Ethernet port on
the laptop computer.
7. Connect the mini-HDMI end of the Link
cable to the Link port on the side of the
panel.
Customer Support
[ViZion DR+ 1417V2 Wireless Panel Installation Manual]
Note: follow the instructions below
AFTER COMPLETING ALL STEPS in
this installation manual. For now, leave
the Link cable connected until installation
is complete.
•
Unpack the TP-Link AC750 AP.
•
Make sure the mode switch on
the side of the access point is set
to AP/Rng Ext/Client.
•
Connect the supplied USB cable
from the laptop to the access
point (supplies power to the
device when plugged in).
•
Connect the supplied Cat5
Ethernet cable from the laptop
network adapter to the access
point.
8. Proceed to Section 4.
1.800.366.5343 –
HCITsupport@konicaminolta.com
13
[Ultra 4.2.9.0]
Advertisement
Table of Contents
