Power Pack & Cell Electrode Installation; Power Pack Installation; Cell Electrode Installation - Pool Pro CPP Series Installation & Operating Instructions Manual

4. POWER PACK & CELL ELECTRODE INSTALLATION

4.1 Power Pack Installation

• The Pool Pro Power Pack has a Ingress Protection Rating of IP23 enabling it to be installed
• The Power Pack shall be installed according to AS/NZS 3000 wiring rules.
• The Power Pack should be installed in a well ventilated position ideally away from sunlight
• Ensure that the Power Pack is not stored near chemicals, fertilisers or in a closed
• When mounting the Power Pack on a post it is recommended to install a flat panel at least
• Mount the Power Pack with the Green Plugs and Mounting Screws provided.
• Fit the Black Plastic Rivets that hold the Acrylic Front in place as follows:
A

4.2 Cell Electrode Installation

• Connect the Cell Housing horizontally in the return line to the pool (use reducing bushes
• Direction of water flow though the Cell Housing is not critical although we do recommend
• Check that the 0-ring is clean, greased with silicone grease
• Fit the Cell Electrode and ensure Cell Locking Ring is firmly tightened by hand
• Connect the leads from the Cell Electrode to the Junction Box under the Power Pack
• Plug the Power Pack 3 pin plug into a suitable weatherproof RCD protected lOamp outlet
D
outdoors. Regulations require that the Power Pack shall be installed outside the pool zone.
and rain to prolong life and at least lm above ground to prevent run off water entry.
unventilated shed with similar products as the fumes will cause excessive corrosion and
damage to the Power Pack and Control Board.
the size of the Power Pack to act as a waterproof backing plate.
� Remove the outer plastic tube from the inner pin on both rivets.
� Align the Acrylic Front and insert the outer tube on both sides.
� Insert the inner pin that will expand the tube and hold the Acrylic Front in place.
The Power Pack should be mounted no further than 1.5 metres from the chlorinator Cell,
for ease of operation of the controls on the Power Pack.
supplied if 40mm PVC pipe) using high pressure PVC glue. The Cell Housing can be mounted
vertically but provision must be made for a gas trap.
entry from the closed end of the Cell Housing and exit from the end closest to the Cell
Locking Ring. The reason is to cause less water hammer over time on the Cell plates.
jelly) and securely located in the Cell Housing.
a tool to tighten).
ensuring the colours match that indicated on the Junction Box (RED - closest to the front,
WHITE - in the middle and BLACK- closest to the rear).
and then plug the pump into the 3 pin AC Socket located at the bottom of the Power Pack.
Should you require further information visit
www.poolpro.com.au
use petroleum based
(DO NOT
(DO NOT
use