Chlorinator Maintenance; Inspecting And Cleaning The Power Pack - Pool Pro CPP Series Installation & Operating Instructions Manual

8. CHLORINATOR MAINTENANCE

Maintenance of your Pool Pro Salt Water Chlorinator is simple and a saltwater chlorinator
has to be one of the most productive pieces of equipment on your swimming pool so it
requires some basic maintenance.
While water chemistry will always be the most important form of maintenance there are also
other hints and pointers to take note of.
•
• To extend the life of your unit we always recommend installation in an under cover area
• Placing the unit in a closed shed or similar environment with chemicals, fertilisers and
• Keep the chlorinator off at all times during backwash cleaning of your filter by turning the
• Check that the Power Pack Junction Box screws are tight and Cell leads are in sound

8.1 Inspecting and Cleaning the Power Pack

Little or no maintenance is normally required with the Pool Pro Power Pack.
Ensure the Power Pack 3 pin plug plugs into a suitable weatherproof RCD protected lOamp
outlet. Ensure that the pump plugs into the 3 pin AC Socket located at the bottom of the Power
Pack. Check all plugs and cords for damage. If damaged then it should be replaced by the
manufacturer, their agent or similar qualified person, in order to avoid a hazard.
If the chlorinator is to be hard wired, then a qualified electrician must complete the installation.
The Pool Pro Power Pack has small air vents to allow internal components to remain
cool in hot weather. It has a special oil spray applied to the inside of the unit during
production to stop the insects from entering the unit. To help assist in keeping the insects
away, apply a surface spray periodically on the wall or post that the unit is mounted on.
DO NOT
Allow adequate time for the spray to dry before turning power on again.
m
cover the Power Pack with towels or similar. There are vents that could be closed
DO NOT
and these need air to keep the unit cool.
away from the elements.
other corrosives will damage the unit and could void your warranty.
Cell Switch to the OFF position. Please remember to turn it on once done and return the
unit to AUTO mode.
condition at least once a year.
spray directly into the Power Pack and make sure the power is off when you spray.
Should you require further information
visit www.poolpro.com.au