Table of Contents
Advertisement
If your furniture is functional, the elements will be supplied individually.
To assemble them, please proceed as follows:
Assemble the relevant parts with the connecting sides together. With the help of another person, carefully lift up the piece of furniture and place
it on its back. You should ensure that the surface is clean and level in order to avoid damage.
As se mbl in g a s e a t u n it wi th out f un cti on ont o seat u n i t w i t h fu n c t i o n
Connect the cable that comes out of the seat unit to the transformer (which is packaged
separately). For a secure hold, click the strain-relief bush over these connections.
▻ Fig. 1
Extend the function and position the seat unit with function so that the marked drilled holes
▻ Fig. 2 and 3 are opposite the drilled holes in the side of the seat unit without function. Insert
the 3 screws supplied from the inside to the outside (from the seat unit with function in the
direction of the seat unit without function)through the drilled holes. ▻ Fig. 4
Screw in the screws by hand until the thread catches (at least 5 turns) and tighten with a 13mm
spanner until hand-tight.
To avoid damaging the mechanism, check before retracting the function that no cables or
objects are blocking the mechanism.
Before turning over the connected elements, please also take note of how to assemble the
height-adjustable supports (see page 16).
–14 –
1
3
2
4
Advertisement
Table of Contents
