Table of Contents
Advertisement
A s se mbl in g a s e a t u n it wit h f u nct io n o n bo t h si des
Put the screws supplied through the drilled holes on one seat unit ▻ Fig. 5 and then through
the other seat unit. Attach the washers and then the nuts onto the screws and tighten them
with a 13mm spanner (not included) until they are hand-tight. ▻ Fig. 6 and 7
For securing and better connection of the elements, take the enclosed metal plate and the
hexagon screws (M8 x 30 mm) and tighten them with a 13mm spanner (not included) until
they are hand-tight. ▻ Fig. 8 and 9
The connecting cable for the power supply must then be connected to the second seat unit. To
do so, you must insert the plug into the motor until it engages (top slot). ▻ Fig. 10
The cable for the seat element with side part is supplied from the factory already inserted into
the motor. You should make sure that it is positioned correctly.
✓
Right!
The connecting cable should be underneath the mechanism! ▻ Fig. 11
X
Wrong! The cable should not be through the mechanism! Risk of crushing! ▻ Fig. 12
Before turning over the connected elements, please also take note of how to assemble the
height-adjustable supports (see page 16).
Connect the cable that comes out of the seat unit to the transformer (which is packaged
separately). For a secure hold, click the strain-relief bush over these connections.
▻ Fig. 1 (see page 14).
–15 –
6
7
8
9
10
11
12
✓
5
Advertisement
Table of Contents
