Table of Contents
Advertisement
M oun t ing t h e h e ig ht- a d j us t able s up po rt f e e t
Depending on composition, different high support feet are enclosed. ▻ Fig. 13
Before you can install them, you need to remove the transport feet. ▻ Fig. 14
When turning in the support feet, observe that the short thread end at the support
foot is on top! ▻ Fig. 15
Turn the support foot/ support feet into the elements, observing the right height..
For elements without function, a HIGH support foot is needed
(when a chuck is placed under the furniture)! ▻ Fig. 16
Elements with function need the LOW support foot
(if the function/mechanic system is visible)! ▻ Fig. 17
Screwing in and carefully setting up is followed by proper adjustment. If your furniture feet
are not pre-installed for transport-technical reasons, observe the separate
Mounting of the furniture feet
Cor r ect s e tt i ng o f t h e s u p po rt f e e t
To prevent damage to the furniture, the support foot must always be turned out to match in
height. The sofa must not "sag". The support foot is adjusted in height by turning the bottom of
–
the foot.
Turning clockwise
✓
Correct! Foot is placed on the floor – furniture is straight and does not sag!
Wrong!
Foot is suspended above the floor – furniture sags!
.
+
Turning counter clockwise.
enclosure 13
–16 –
13
14
15
16
17
✓
✓
Advertisement
Table of Contents
