Date & Time Menu - Dimension One Spas REFLECTIONS series Owner's Manual

Reflections Collection
= Change water: A 120-day reminder to change out the hot tub
water.
= Spa check: A 730-day reminder to have a general check up
performed.
= Change ozonator: A 540-day reminder to change out the
ozonator with a new unit.
= Reset all reminders: Will reset all the reminders, at the same
time, to the maximum setting.
B. Standby
When you tap the "Standby" tab, the display
changes to Figure 12.2e. This feature turns the
pumps OFF to perform routine maintenance
such as cleaning the filters. To return to normal
operations, press
timeout in 30 minutes. During the 30 minutes the display
will remain in the Standby menu, Figure 12.2e.
C. Dealer info
When you tap the "Dealer info" tab, the display
changes to Figure 12.2f. This feature provides the
contact information for your dealer.
D. Vision cartridge
When you tap the "Vision cartridge" tab, the display
changes to Figure 12.2g. This feature deactivates
the vision cartridge maintenance reminder, if you do
not have the cartridges installed.
12.3 Date & Time Menu
Programming the date and time is a simple and fast process. From the
settings menu, Figure 12.3a, press the "Date & Time" tab. The display
will change to Figure 12.3b.
Settings
Figure 12.3a
Page 34
. This feature will
Cancel
Settings
8:01 am
Water Care
Maintenance
Date & Time
Keypad
Electrical Config
Settings
All pumps off! Press
Cancel to exit Standby
mode.
Cancel
Settings
Chemicals, parts and service
available at:
Settings
Press the Confirm key for 5
sec. to deactivate the Vision
cartridge maintenance
reminder.
Settings
Date & Time
Set Date
Set Time
Figure 12.3b
Standby
8:01 am
Figure 12.2e
Dealer info
8:01 am
Figure 12.2f
Vision cartridge
8:01 am
Confirm
Figure 12.2g
8:01 am