Safety Installations; Emergency Switch (If Applicable); Security Installations; Safety-Switch Back Stop (If Applicable) - Uniflex HM 200 Operating Manual

Safety installations

Emergency switch
Note:
the emergency switch must be activated in all situations where injuries of people or damage on
the machine can arise:
The emergency switch is located on the control board.

Security installations

Before each use of the crimping machine or the system, all safety installations must be fitted and working correctly.
Authorized personnel may only remove safety installations:

After the complete stop of the machine.

After safeguarding against accidental switching on.
In the case of partial delivery of components the provided safety instructions and notes need to be displayed
correctly by the user.

Safety-switch back stop (if applicable)

For safety reasons the back stop stops whenever during the crimping process the hose no longer touches the back
stop.

Path limitation

Adjust the opening diameter of the crimping tool so that it exceeds the diameter of the hose fitting only fractional.
This setting protects the operator from reaching into the crimping area with his or her hand.

Hazards and safety measures

Personal safety

Irrespective of the local accident prevention regulations, the following instructions should be observed as a means
of protecting the health and safety of the maintenance and operating personnel:

Never reach into the machine with your hands during operation.

Always keep a copy of the operating manual at the place of use of the machine.

Make sure that all safety and danger notices on the machine (if applicable) are always legible.

Only operate the machine when all safety devices are in working order.

Before starting up the hydraulic unit, make sure that the running machine can endanger no one.

Do not place any objects on the floor near the workplace.

Wear working gloves, especially when heavy work pieces have to be loaded.

Do not bring work materials to the machine with a fork lift truck.

Wear safety shoes.
Danger:
Never reach into the crimp tool with your hands while the electric motor is running! Always make
sure that there is an adequate safety distance of at least 120 mm to the crimp tool when you are
inserting a hose fitting.
Warning:
Switch off the machine using the main switch during all maintenance and setting works!
Danger:
When the machine is handled improperly, there is the danger of hands getting caught and
crushed!
(if applicable)
UNIFLEX-Hydraulik - 9 - www.uniflex.de