Hm200Ecoline Connecting The Electric Supply - Uniflex HM 200 Operating Manual

HM200Ecoline Connecting the electric supply

Caution:
This work should only be performed by a qualified electrician! Note the marked voltage on the
type plate and select the appropriate electric circuit diagram!
Works on live wires are hazardous!

Switch the main connection of the hose crimper off-circuit and make sure that it cannot be switched on
again.

Connect the electric connecting cable to the connection of the power supply. For the correct voltage
refer to the type plate.
Note:
The rotating direction of the electric motor is indicated by an arrow on the motor!
Note:
The connecting plug must comply to current local electrical regulations!

Check the rotating direction of the electric motor (only with 3-Phases)
If crimping tool doesn't drive or drives very slowly, direction of motor is wrong.

Switch the main connection of the hose crimper off-circuit and make sure that it cannot be switched on
again.

If the motor does not rotate in the right direction, two phases must be switched as shown:
Attention:
The motor will be damaged if it rotates in the wrong direction for some time.
UNIFLEX-Hydraulik - 15 - www.uniflex.de