General Notes For Crimping; Control Of The Hose Crimper - Uniflex HM 200 Operating Manual

General Notes for Crimping

It is important to always crimp centrically, otherwise the result may be conical crimping or increased abrasion. The
crimp tool should only be opened far enough to insert or take out the hose easily. Too large opening paths may
lead to crushing injuries and time loss.
Check the crimp diameter after the first crimping, if there are differences between real and nominal value, the crimp
diameter needs to be adjusted.
Picture 4, Check the crimp diameter
Differences may occur due to springing open of the fitting after the crimping and as a result of hose or fitting
tolerances or differing material hardness of the fittings.
Attention:
Always insert a full set of equal crimp dies with equal marking and diameter!

Control of the hose crimper

For operating the UNIMATIControl B-Plus please refer to Operating Manual Control.
HM 200 Ecoline
UNIFLEX-Hydraulik - 19 - www.uniflex.de
HM 200