Calibrate the crimp micrometer
If you notice a difference of the set crimp diameter on the work piece to the crimp diameter marked on the
crimp die, while the crimp micrometer is in zero-position, it needs to be recalibrated.
Note:
Make sure that there are no measuring mistakes, e.g. due to springing open of the work piece.
Requirements
Remove the screws on the cover or front plate and take it off.
Loosen the counternut of the contact screw.
2,5 rotations of the contact screw are equal to 1 mm change in the crimp value.
Counternut
Contactscrew
UNIFLEX-Hydraulik - 21 - www.uniflex.de