Hydraulic Power Unit - Only Ecoline Dc; Filling With Hydraulic Oil; Ventilate The Hydraulic System - Uniflex HM 200 Operating Manual

Hydraulic Power Unit – Only ECOLINE DC:
For commissioning the HM 200 Ecoline DC an external Hydraulic Power Unit is needed
Hydraulik – Power Unit
Or
As well as 1 set of hoses
When using other power units the following technical data must be adhered to:
Motor power max. 3 KW, Pump delivery rate 9 l /min 280 bar max. pressure.
Warning:
For security reasons the HM 200 Ecoline DC is restricted to 280 bar pressure internally.
Connect the plug of the hydraulic power unit as shown on the pictures to the socket in the rear of the machine.

Filling with hydraulic oil

Caution:
If the UNIFLEX- crimping machine was ordered without hydraulic oil, it must be filled with the
appropriate new, clean and filtered (10µ) hydraulik oil before commissioning.
The following oil must be used:
HM 200, HM 250, HM 260, HM 200 Ecoline :
HM 200 Ecoline DE:
Close the oil filler on the tank plate when the correct oil level has been reached.

Ventilate the Hydraulic System


Switch on the hose crimper.

Open and Close the tool a few times.

The Hydraulic system is ventilated. The machine is now ready for operation.
Attention:
Always ventilate when the hydraulic oil is changed.
z.B. UNIFLEX Art. Nr. PUF 4L 2.0_90 (12V)
z.B. UNIFLEX Art. Nr. PUU 45 L 3,0_00
z.B. UNIFLEX Art. Nr. SA Ecoline 2xx / 1200
UNIFLEX-Hydraulik - 13 - www.uniflex.de
HM or HV 46 ISO6743/4
(HLP 46 DIN51524)
HM or HV 68 ISO6743/4
(HLP 68 DIN51524)