Fitting The Furniture Door - Miele K 34673 iD Operating And Installation Instructions

Installing the appliance
Only for an appliance with a niche
height greater than 140 cm
For additional stability of the appliance
in the unit, push the rods supplied in
underneath the appliance between it
and the floor of the housing unit:
 Then secure handle  to one of the
rods .
 Use the handle to push the rod into
the guide as far as it will go. Remove
the handle and fit it to the other rod
and push this into its guide as far as it
will go.
Important. Keep the handle some-
where safe in case you ever need to
fit the appliance into a new housing
unit.
 Close the appliance door.
82

Fitting the furniture door

If fitted in a run of units make sure that
the top edge of the furniture door is at
the same height as neighbouring unit
doors.
The furniture door must be fitted cor-
rectly and not under tension.
The next section gives instructions on
how to fit a furniture door that is at
least 16–19 mm thick.
 A gap of 8 mm is set ex-works
between the appliance door and the
fixing bracket. Double check this gap
and reset it if necessary.
 Push fitting aids  up to the height of
the furniture door: the lower edge X
of the fitting aids must be at the same
height as the upper edge of the fur-
niture door being fitted (see  on the
diagram).