Checklist Of The Mechanical Construction; Checklist For Configuration/Parameter Assignment - Siemens SIMATIC IM 178-4 Manual

5.2

Checklist of the Mechanical Construction

Table 5-1 Checklist of the Mechanical Construction
Step
1 Installation of the IM 178-4 (see Chapter 2)
2 Wiring the IM 178-4 (see Chapter 3)
Digital inputs
Digital outputs
Analog outputs
Sensor connections
Power supplies
3 Peripheral connector
The peripheral connector must be locked and secured by screws.
4 Setting the DP address (see Section 5.1)
5 Bus connector
The bus connector must be secured by screws
6 Check the shields of the individual cables
7 Turn on the power supplies
5.3

Checklist for Configuration/Parameter Assignment

Table 5-2 Checklist for Configuration/Parameter Assignment
Step
1 Have you copied the GSE file and the bitmap file to the local module
catalog? (see Section 4.1)
2 Does the PROFIBUS address set on the module match the configured
address?
3 Have you set the user-specific parameter assignment data for the DP
attachment to 40
4 Have you configured the technological slot depending on your requirements
to "Q4 words/I12 words" or "Q4 words/I12 words consistent"? (see Section
B.1)
5 Have you set the user-specific parameters to values suitable for the position
encoder being used?
IM 178-4
C79000-G7076-C178-01
What needs to be done?
What needs to be done?
, 20 , 00 ? (see Section B.2.2)
H H H
Preparing for Startup
5-3