Gree GWC12NC-K3NNA3E Service Manual page 16

Function and Control
LIGHT icon:
19
is displayed by pressing the LIGHT button.Press LIGHT button again to clear the display.
LOCK icon:
20
is displayed by pressing "+" and "-" buttons simultaneously.Press them again to clear the display.
SET TIME display:
21
After pressing TIMER button, ON or OFF will blink.This area will show the set time.
TURBO icon:
22
is displayed when pressing theTURBO button.Press this button again to clear the display.
DIGITAL display:
23
This area will show the set temperature. In SAVE mode,"SE" will be displayed. During defrosting operation, "H1" will be displayed.
X-FAN icon:
24
is displayed when pressing the X-FAN button. Press this button again to clear the display.
FAN SPEED display:
25
Press FAN button to select the desired fan speed setting(AUTO Low-Med-High).Your selection will be displayed in the LCD windows,
except the AUTO fan speed.
ON/OFF:
1
Press this button to turn on the unit. Press this button again to turn off the unit.
MODE:
2
Each time you press this button,a mode is selected in a sequence that goes from AUTO, COOL,DRY, FAN, and HEAT *, as the
following:
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not be displayed on the LCD, and the unit will
automatically select the suitable operation mode in accordance with the room temperature to make indoor room comfortable.
+ :
3
Press this button to increase set temperature. Hold it down for above 2 seconds to rapidly increase set temperature. In AUTO mode,
set temperature is not adjustable.
-:
4
Press this button to decrease set temperature. Hold it down for above . 2 seconds to rapidly decrease set temperature. In AUTO
mode, set temperature is not adjustable.
FAN :
5
This button is used for setting fan speed in the sequence that goes from AUTO,
6
Press this button to set up & down swing angle, which circularly changes as below:
This remote controller is universal. If any command
indicates the guide louver swings as:
AUTO COOL DRY FAN
*Note: Only for models with heating function.
AUTO
Low speed Medium speed
OFF
, or
HEAT*
, , to then back to Auto.
High speed
is sent out, the unit will carry out the command as
13