Table of Contents
Advertisement
on the groove of the electric air pump. Remove the
valve dust cap of the damaged tyre, and connect the
hose connector of the repair fluid reservoir to the
tyre valve. Check if the power switch of the electric
air pump is off (with "O pressed), then connect the
electric air pump plug to the 12V power socket in
the centre console, and turn the ignition switch to the
ACC or ON/RUN position.
EMERGENCY INFORMATION
Note:
To avoid battery discharge,
recommended to keep the engine running.
3 Switch on the power switch of the electric compressor
(i.e., press "-"), to start pumping sealant into the
tyre. The tyre sealant bottle will become empty after
approximately 30 seconds. The tyre should reach the
specified pressure within 5 to 10 minutes.
Note: The pressure gauge may briefly reach 6
bar (87 psi), then the pressure begins to drop to
normal.
4 When the required pressure is reached, switch off the
power switch of the electric compressor (i.e., press
"O").
Note:
If the required pressure cannot be
reached within 10 minutes, please disconnect the
compressor, drive the vehicle 10 metres (33 feet)
approx forward or backward to allow the sealant
to spread within the tyre. If the required pressure
can still not be reached, the tyre is severely
damaged and you should seek assistance from an
MG Authorised Repairer.
it is
5
199
Advertisement
Table of Contents
