Dometic CAM 30C Installation And Operating Manual page 7

PerfectView
When the negative terminal of the battery is disconnected, all data stored in the volatile memory
will be lost.
• The following data must be set again, depending on the vehicle equipment options:
– radio code
– vehicle clock
– timer
– on-board computer
– seat position
You can find instructions for making these settings in the appropriate operating instructions.
Observe the following installation instructions:
• Secure the parts of the camera installed in the vehicle in such a way that they cannot become
loose under any circumstances (sudden braking, accidents) and cause injuries to the occu-
pants of the vehicle.
• Secure any parts of the system covered by the bodywork in such a manner that they cannot be
come loose or damage other parts and cables and impair vehicle functions (steering, pedals,
etc).
• To prevent damage, when drilling ensure that there is sufficient space on the other side for the
drill head to come out (fig. 1, page 2).
• Deburr all drill holes and treat them with a rust-protection agent.
• Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be performed by qual-
ified specialists.
Observe the following instructions when working with electrical parts:
• Only use a diode test lamp or voltmeter to test voltages in electric cables.
Test lamps with an illuminant consume voltages which are too high and which can damage the
vehicle's electronic system.
• When making electrical connections, ensure that
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection (fig. 2, page 2).
• Insulate all connections.
• Secure the cables against mechanical wear with cable binders or insulating tape, for example
to existing cables.
EN
Safety and installation instructions
7