Dometic CAM 30C Installation And Operating Manual page 11

PerfectView
• Always use the supplied insulation pad (fig. 3 3, page 2). This prevents residual current
caused by a poor earth connections in the vehicle. Residual current can cause lines of inter-
ference in the picture or humming in the loudspeakers or even damage components.
• Observe the fastening instructions:
– There must be sufficient space behind the chosen installation location to be able to carry
out the mounting procedure.
– Suitable measures must be taken to prevent water penetrating through any holes made
(e.g. by using screws and sealant and/or spraying the outer attachment parts with a
sealant).
– The location on the body where you wish to attach the camera must be rigid enough to
allow the camera to be tightly fastened.
• Check beforehand that there is sufficient space on the other side for the drill head to come out
(fig. 1, page 2).
• If you are not sure about the location you have chosen, ask your vehicle manufacturer or dealer.
I
NOTE
We recommend greasing the threads of the bolts to prevent corrosion.
To perform the installation, proceed as follows:
➤ Hold the bottom camera holder on the chosen location and mark two points for the drill holes
(fig. 6, page 4).
➤ Using a hammer and centre punch, gently pre-punch the previously marked points to prevent
the drill head from slipping off.
If you want to screw on the bottom camera holder with self-tapping screws
A
CAUTION!
The holder may only be attached to steel panels with a minimum thickness of 1.5 mm
using self-tapping screws.
➤ Drill Ø 2 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Place the insulating plate (fig. 3 5, page 2) where the bottom camera holder is to be fitted.
The insulation plate serves as a seal and protects the paint.
➤ Screw on the camera holder using the self-tapping screws.
EN
Mounting the camera
11