Samsung AM080xXV Series Service Manual page 252

How to set the key function of the outdoor unit
AM140/160/180/200/220/240/260/280/300KXV
Optional item Input unit SEG1 SEG2 SEG3 SEG4
Long-pipng
condition
setting
(Setting Main
is unnecessary
if high-head
condition is set)
Energy control
Individual
Operaton
Rotation defrost
Main
(HR only)
Expand
operational
temperature
Individual
range for cooling
operation
(HR only)
Channel address Main
Snow
accumulation
Main
prevention
control
Unused option Main
Unused option Main
Speed operation Main
Max capacity
Main
restriction
Gasleak
Main
Pumpdown
Samsung Electronics
0 0
0 1
0 9
0 2
0 0
0 1
1 0
0 2
0 0
1 1
0 1
0 0
1 2
0 1
A U
1 3
0 ~ 15
0 0
1 4
0 1
1 5 0 0
1 6 0 0
0 0
1 7
0 1
0 0
1 8
0 1
0 0
1 9
0 1
(cont.)
Function of the option
Disabled (Factory default)
LEVEL 1
LEVEL 2
Basic (Factory default)
Energy saving
Power
Disabled (Factory default)
Enabled
Disabled (Factory default)
Enabled
Automatic setting
(Factory default)
Manual setting for channel
0~15
Enabled (Factory default)
Disabled
Unused option
Unused option
Disabled (Factory default)
Enabled
Enabled (Factory default)
Disabled
Disabled (Factory default)
Enabled
Remarks
When equivalent length of
farthest indoor unit from
the outdoor unit is between
100~170m
When equivalent length of
farthest indoor unit from the
outdoor unit is over 170m
Energy control option
of designated operation
sequence.
Operating in energy
saving mode, capacity
might decrease compared
to normal operation mode.
When enabled, continuous
heating operation is possible
but heating performance
will decrease during rotation
defrost operation.
When enabled, continuous
cooling operation is possible
even in low temperature
condition up to -15°C, but
noise of the MCU will increase.
Address for classifying the
product from upper level
controller. (DMS, S-NET 3, etc )
During snow accmulation , the
fan may spin even when the
unit is not in operation.
Unused option by this model.
Unused option by this model.
Enabling this setting will
command the air conditioner
to cool/ heat faster at initial
start-up.
However, this function will
not work when High-head
condition setting or Longpiping
condition setting is
enabled.
Restrict excessive capacity
increase when operating
indoor units with small
capacity.
If the gas leak occurred it
should be entered in the
pumpdown operation.
8-11