Table of Contents
Advertisement
if you fasten your seat belt while the vehi‐
R
cle is in motion
Before starting the engine: adjust the
#
driver's seat, the head restraint, the
steering wheel or the mirror and fasten
your seat belt.
& WARNING Risk of becoming trapped if
the seat height is adjusted carelessly
If you adjust the seat height carelessly, you or
other vehicle occupants could be trapped and
thereby injured.
Children in particular could accidentally press
the electrical seat adjustment buttons and
become trapped.
While moving the seats, make sure that
#
hands or other body parts do not get
under the lever assembly of the seat
adjustment system.
& WARNING Risk of injury due to head
restraints which are not installed or are
adjusted incorrectly
If head restraints are not installed or are
adjusted incorrectly, the head restraints can‐
not provide protection as intended.
There is an increased risk of injury in the
head and neck area, e.g. in the event of an
accident or when braking.
Always drive with the head restraints
#
installed.
Before driving off, make sure for every
#
vehicle occupant that the center of the
head restraint supports the back of the
head at about eye level.
Do not interchange the head restraints of the
front and rear seats. Otherwise, you will not be
able to adjust the height and angle of the head
restraints correctly.
Adjust the head restraint fore-and-aft position so
that it is as close as possible to the back of your
head.
& WARNING Risk of injury or death due to
incorrect seat position
The seat belt does not offer the intended level
of protection if you have not moved the seat
backrest to an almost vertical position.
When braking or in the event of an accident,
you could slide underneath the seat belt and
sustain abdominal or neck injuries, for exam‐
ple.
Adjust the seat properly before begin‐
#
ning your journey.
Always ensure that the seat backrest is
#
in an almost vertical position and that
the shoulder section of your seat belt is
routed across the center of your shoul‐
der.
* NOTE Damage to the seats when moving
the seats back
The seats may be damaged by objects when
moving the seats back.
When moving the seats back, make sure
#
that there are no objects in the footwell,
under or behind the seats.
1
Seat fore-and-aft position
2
Seat height
3
Seat backrest inclination
%
Depending on the seat model, individual
adjustment options may be omitted.
To adjust the seat fore-and-aft position: lift
#
lever
1
and slide the seat into the desired
position.
Make sure that the seat is engaged.
#
To set the seat height: keep on pressing or
#
pulling lever
2
until the required seat height
is reached.
To adjust the seat backrest inclination:
#
turn handwheel
3
until the desired position has been reached.
Seats and stowage
forwards and backwards
61
Advertisement
Table of Contents
