Programming Help For Lokmaus 2 /R3 - Multimaus; Pro - roco multiMAUSPRO Getting Started

The readout of the decoder data ("PROGRAM-
MING" menu) triggers the message "NO CON-
FIRMATION" in the display.
POM mode: Programming is confirmed,
but the decoder does not react to an altered
value
Resetting (Part 3, Chapter 3.3, page 76) of the
multiMAUS is not possible.

PRO

The Turnout reacts incorrectly or the turnout set-
ting does not match display
Display shows OFFLINE
5.8.1 Programming Help for Lokmaus 2 /R3 –
Previous operating manuals for digital ROCO articles (e.g. 42624 turnout drive) only describe the standard pro-
gramming mode for Lokmaus 2 /R3. The following includes a table which compares the programming procedure
for the Lokmaus 2 /R3 and quick programming (see chapter 2.8 on page 64) on the multiMAUS
For more information see the operating manual for the Lokmaus 2 /R3. To program CV29 see the operating
instructions included with the decoder.
CV
1 – Address
2 – Minimum speed
3 – Start-up delay
4 – Braking delay
5 – Maximum speed
29 – Decoder settings
Change speed steps
– The decoder cannot be read out.
– The multiMAUS
item 2.5, page 73).
– Contact problems of the locomotive on the track?
– Decoder needs to be reset: Switch the track voltage off
and back on again using the "STOP" key (emergency
stop). See the operating manual for the decoder.
– Press the "shift" and "MENU" keys simultaneously and
press the "Light /OK" key briefly. The display lights up
briefly.
– This resets the multiMAUS
settings. A reset also deletes the locomotive library and
should therefore only be carried out if absolutely nec-
essary.
– Turn the plug on the turnout drive.
The selected action needs a radio connection with the
multiZENTRALE
is showed.
multi
multiMAUS
PRO
+
+
+
+
+
Can only be programmed in menu
mode (see page 73)
+
/
is set to "POM" mode (Part 3, menu
PRO
completely to the factory
PRO
. If this connection does not exist OFFLINE
PRO
MAUS
PRO
Lokmaus 2/R3 (for comparison)
+
+
+
+
+
+
+
��
.
PRO
/
87