Removing The Keyboard - Clevo N770WU Service Manual

Disassembly

Removing the Keyboard

Figure 2
1. Turn off the computer, turn it over to remove the battery
Keyboard Removal
2. Remove screws
3. Open it up with the LCD on a flat surface before pressing at point
a. Remove the screws.
cial eject stick
b. Release the keyboard by
4. Carefully lift the keyboard
pressing at point 3 .
c. Disconnect the keyboard
board ribbon cable from the locking collar socket
ribbon cable from the
5. Carefully lift up the keyboard
locking collar socket.
6. Reverse the process to install the keyboard (do not forget to replace all the screws).
d. Remove the keyboard.
a.
b.
4. Eject Stick
6. Keyboard
• 2 Screws
2 - 6 Removing the Keyboard
- from the bottom case
1 2
to do this) while releasing the keyboard in the direction of the arrow
4
up, being careful not to bend the keyboard ribbon cable
6
off the computer
6
1
2
5
3
4
(page 2 - 5).
(Figure 2a).
to release the keyboard module (use the spe-
3
(Figure 2d).
8
(Figure 2e).
c.
d.
as shown (Figure 2c).
5
. Disconnect the key-
7
6
7
8 8
6