Table of Contents
Advertisement
7. DO NOT forcfully pull or excessively bend cooling coil hose.
Handle cooling coil hose with care. Pulling on or bending hose to a radius of more than
50mm may break cooling line and result in malfunction or other equipment damage.
8. Connect to a properly rated power supply.
Connect power cable to a suitable facility outlet or terminal, according to the following
electrical requirements.
Power
requirements:
1. Check the line voltage on outlet or terminal to be used and properly evaluate whether to
utilize a line being shared by other equipment. If the unit is not activated by turning on the
main power switch (ELB), take an appropriate course of action, such as connecting unit to
a dedicated power source.
2. If multiple power cables are connected to a single outlet, input voltage to unit may drop,
causing degraded cooling and temperature control performance.
Never connect ground wire to gas lines, water lines or telephone grounding lines. Fire or
electric shock may result.
9 Handle power cable with care.
Never operate unit with power cable bundled or tangled; and do not modifiy, bend, forcibly
twist or pull on power cable. Doing so may cause fire and/or electrical shock.
Do not risk damage to power cable by positioning it under desks or chairs, or having it
pinched between objects. Doing so may cause fire and/or electrical shock.
Do not place power cable near kerosene/electric heaters or other heat-generating devices.
Doing so may cause power cable insulation to overheat, melt and/or catch fire, which may
result in electric shock.
Turn off main power switch (ELB) immediately and disconnect from facility terminal or outlet, if
power cable becomes partially severed or damaged in any way. Failure to do so may result in
fire or electric shock. Contact a local dealer or Yamato sales office for information about
replacing power cable if it is damaged.
Always connect power cable to appropriate facility outlet or terminal.
2. PRE-OPERATION PROCEDURES
BE201 (50/60Hz) Single phase 115V 2.6A/2.0A Max.3.0A
BE201F (50/60Hz) Single phase 115V 3.6A/2.0A Max.3.0A
BE301 (50/60Hz) Single phase 115V 4.7A/4.3A Max.5.5A
Placement Precautions & Procedures
7
Caution
Advertisement
Table of Contents
