Menu Guides; Pairing Menu - Technotherm TPF-Eco Control Manual

•
Thermostat will display number of receivers found.
•
Hold down OK for 5 seconds to remove the receivers. The thermostat will flash the number
of connected receivers until it reduces to 0. This removes the association from both the
panel and the thermostat.
NOTE – under rF03, the thermostat will only break associations with receivers that are in range. If
the number of connected receivers does not reduce to zero, this is because there are panels
associated with the thermostat that it cannot currently communicate with. This may be because the
panel is switched off at the wall or has been moved out of range.
•
If you want to remove associations with panels you can't connect to – for instance if the
panel has been lost or given away – follow the steps above but proceed to rF04.
o Press OK.
o Hold down OK for 5 seconds until the number of connected receivers
reduces to zero.
NOTE – This channel removes wireless associations from the thermostat but not the
receiver. If you later find the panel, you will need to remove its association with the
thermostat by holding down the top button on the receiver for over 30 seconds until
the indicator flashes.

Menu Guides

All the TPF-Eco's adjustable settings can be accessed via two menus: the receiver menu and the
configuration menu. Both can be reached via shutdown mode:
•
Hold down second button from left for 5 seconds
•
To go to pairing menu, hold down 2
•
To go to configuration menu, press OK.
1F – Pairing Menu
This menu allows you to add and remove associations with panels, as well as troubleshoot
connectivity issues. Use +/- keys to scroll through menu items and OK to select.
•
rF01 – Thermostat searches for receivers.
o See
"How to connect your
•
rF02 – Displays signal strength between thermostat and receivers.
o Shows a number from 0 to 4, where 4 indicates maximum strength.
o You can use this for troubleshooting. If the number is low, move the thermostat
closer to the panels.
•
rF03 – Remove wireless associations (from thermostat and receivers).
o See
"How to disconnect your
nd
button from left until you see "rf01".
panels" for full guide to pairing.
panels" for full guide.
17/04/2019 – TPF-Eco version u111