NOTE – By default the thermostat sets modes to hourly intervals. However, if you prefer, you can set
it to program at half-hourly intervals, via CF11 in the
to half-hourly intervals, the bars at the bottom will be unchanged – i.e. still just one bar per hour. In
the event there are two different modes set in one hour – i.e. comfort at 4, economy at 4:30 – the
bar will show as comfort but will heat as economy for the relevant half hour.
1D – Auto Mode
•
Use mode dial to scroll to auto mode
•
Panels will heat as per your set program (displayed at the bottom of the TPF-Eco display).
•
You can temporarily suspend programming using the special event modes:
o
Party mode
▪
▪
▪
▪
▪
▪
o
Away mode
▪
▪
▪
▪
▪
▪
•
Information – You can use the
heating. Press
o
Room temperature
o
Outside temperature (only available if you have an outdoor sensor paired with
the thermostat)
o Total consumption of paired heaters
•
Lock – Hold down
1E – How to Disconnect Your Panels
•
Press
to put the TPF-Eco in shutdown mode:
•
Hold down the second button from the left until you see "tAP", the software version screen.
•
Again, hold down the second button from the left, until you see "rf01", the receiver
configuration screen.
•
Use the + key to advance to "rf03". Press OK to tell the TPF-Eco to search for receivers.
Press
key.
Use +/- keys to set temperature for given period. (5 °C – max comfort).
Press OK.
Use +/- keys to set duration. (30 mins to 12 hours).
Press OK.
The thermostat will display the
timer finishes. Press C on this screen to cancel.
Press
key.
Use +/- keys to set away days. (1 – 365 days).
Press OK.
Use +/- keys to set away temperature. (5 °C – max comfort).
Press OK.
The thermostat will display the
timer finishes. Press C on this screen to cancel.
button on auto mode to check information about your
repeatedly to cycle through:
for 5 seconds to lock.
configuration
menu. When you set a program
symbol and a countdown timer until the
symbol and a countdown timer until the
17/04/2019 – TPF-Eco version u111