What To Do If - Zanussi ZEV8646XBA User Manual

Warning! The sharp objects and abrasive
cleaning agents can cause damage to the
appliance.
For your safety, do not clean the appliance with
steam cleaners or high-pressure cleaners.
Scratches or dark stains on the glass-ce-
ramic cause no effect on how the appli-
ance operates.
To remove the dirt:
1. – Remove immediately: melted plastic,
plastic foil, and food with sugar. If not,
the dirt can cause damage to the appli-

What to do if...

Problem
You cannot activate the appliance
or operate it.
A Sound operates and the appli-
ance deactivates.
A sound operates when the appli-
ance is deactivated.
The appliance deactivates.
The residual heat indicator does
not comes on.
The Automatic Heat Up function
does not operate.
You cannot activate outer ring.
The sensor fields become hot.
comes on
and number comes on.
10
2. Clean the appliance with a moist cloth and
3. At the end rub the appliance dry with a
Possible cause and remedy
• Activate the appliance again and set the heat setting in 10 seconds.
• You touched 2 or more sensor fields at the same time. Only touch
one sensor field.
• The Child Safety Device or the Lock operates. See the chapter Op-
erating instructions.
• There is water or fat stains on the control panel. Clean the control
panel.
You put something on one or more sensor fields. Remove the object
from the sensor fields.
You put something on the
The cooking zone is not hot because it operated only for a short time. If
the cooking zone should be hot, speak to the service centre.
• There is still residual heat on the cooking zone. Let the cooking zone
become sufficiently cool.
• The highest heat setting is set. The highest heat setting has the same
power as the Automatic Heat Up function.
• You decreased the heat setting from
crease the heat setting.
Activate the inner ring first.
The cookware is too large or you out it too near to the controls. Put
large cookware on the rear cooking zones if it is necessary.
The Automatic Switch Off operates. Deactivate the appliance and acti-
vate it again.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some time. Dis-
connect the fuse from the electrical system of the house. Connect
again. If comes on again, speak to the service centre.
ance. Use a special scraper for the
glass . Put the scraper on the glass sur-
face at an acute angle and move the
blade on the surface .
– Remove after the appliance is suffi-
ciently cool: limescale rings , water
rings, fat stains, shiny metallic discolora-
tions. Use a special cleaning agent for
glass ceramic or stainless steel.
some detergent.
clean cloth.
. Remove object from the sensor field.
. Start from and only in-
www.zanussi.com